PIONEERPOS G24-LC manual S100, Set Minimum Time for Terminal to Fall into Sleep Mode

Modem Configuration and Profile

Command Type	Syntax	Response/Action	Remarks
Set	ATS102 = <value>	OK	The Set command sets the delay before
			sending data to the terminal, and
			defines a period between sending the
			wakeup signal and sending data to the
			terminal.
Read	ATS102?	<value>	The Read command returns the current
		OK	value.

The following table shows the S102 parameters.

	Table 3-136: S102 Parameters
<Parameter>	Description
<value>	0 <= value <= 255
	The default value is 30 ms.

Example

ATS102? <enter> 030

OK

ATS102=100 <enter>

OK

ATS102? <enter> 100

OK

(This means if there is data for transmission to the terminal, the G24-L drops the Wakeup Out line, waits 100 ms. and then sends data to the terminal.)

S100, Set Minimum Time for Terminal to Fall into Sleep Mode

ATS100 is a terminal minimum time limit for entering sleep mode.

In order to limit the number of interrupts on the DTE side and reduce data sending delay time on our side, G24-L sends wakeup-out pulse when the interval between one burst of sent/received data to the other is bigger than specified in ATS100.

Command Type	Syntax	Response/Action	Remarks
Set	ATS100=<delta>	OK	The set command sets the terminal
		Or	minimum time limit for entering sleep
		+CME ERROR: <err>	mode.
Read	ATS100?	<delta>	The Read command returns the current
		OK	ATS100 value.

3-204 G24-L AT Commands Reference Manual April 15, 2008