C H A P T E R 5 | Boot Monitor Command Reference |
Command | Description |
netmask | Use this command to specify the netmask. |
| Example: |
| monitor>netmask |
| Enter Netmask [255.255.254.0] |
|
|
nic | Use this command to configure network interface card (NIC) |
| parameters. Assurance of compatibility with some older switches, hubs, |
| or routers, may require that you directly specify the Ethernet speed and |
| duplex mode of the network interface card for the 7190. The nic |
| command, available at the serial console, allows you to specify these |
| characteristics. |
| Example: |
| monitor>nic |
| Auto config NIC card? [y] |
| 1 - 100BaseTx |
| 2 - 10BaseTx |
| Select Media Type (1 or 2): [1] |
| Use Full Duplex? [y] |
| Done Ether config: 100basetx,full_duplex |
|
|
route
save
Use this command to specify the default route (gateway).
Example:
monitor>route
Enter default route [10.1.1.1]
Use this command to save the current configuration. Changes made during the current Boot Monitor session are lost unless you use the save command.
Boot Monitor Command Reference
55
