C H A P T E R 6 | CLI Command Summary |
Command | Description |
config sys | Displays the current status of SSH enable or disable. If the status |
ssh info | was just changed, it reflects the changed status that is pending for |
| the reboot. |
|
|
ssh enable | Enables SSH connections the next time the box is rebooted. |
|
|
ssh disable | Disables SSH connections the next time the box is rebooted. |
|
|
config sys | Displays information about whether the Wizard is enabled or |
wizard info | disabled. By default, Wizard is enabled. |
|
|
wizard enable | Enables the Quick Start Wizard. The Quick Start Wizard is an |
| automated, interactive method to configure the 7190. It is |
| available only through the serial port if enabled after Boot |
| Monitor. |
|
|
wizard disable | Disables the Quick Start Wizard. |
|
|
ntp create <ntpserver>
NOTE: If you used selected Flash load balancing in the Quick Start Wizard, you need to configure NTP.
Adds an NTP server.
Syntax:
ntp create <ntpserver>
where:
ntpserver is the fully qualified hostname or the IP address of the Network Time Protocol Server.
ntp delete | Deletes an NTP server. |
<ntpserver> | Syntax: |
| ntp delete <ntpserver> |
| where: |
| ntpserver is the fully qualified hostname or the IP address of |
| the Network Time Protocol Server. |
|
|
config sys | Displays information about any configured NTP servers. |
ntp info |
|
|
|
| Config Sys Commands |
89
