
C H A P T E R 6 | Intel® NetStructure™ 7190 |
Command | Description |
config dns agents | Configures the IP address of the peer flash sources. These include |
<agentname> | the IP addresses of this 7190 itself and additional 7190s if they |
exist. Up to five unique | |
<ipaddress> | among the sixteen possible agents. |
NOTE: At least one of the (up to 5) unique flash- source addresses must be the IP address of the 7190 itself.
Sets or changes the UDP port number through which flash peers | |
| communicate to each other. The default port number is 2000. |
|
|
Configures a backup source address to which queries are routed, | |
<ipaddress> | in the event of this 7190 not being functional. The backup source |
| address is the IP address of another 7190 or a load balancer with a |
| |
|
|
Configures the port number with which the backup flash source | |
<port#> | communicates with its known peers. The default port number is |
| 2000. |
|
|
interval | Configures the interval at which metrics are gathered from the |
| specified agent. The default is 30 seconds. |
| Syntax: |
| config dns agents <agentname> interval <seconds> |
| where: |
| agentname is the name of the agent whose |
| interval you wish to set. |
| seconds is an integer between 1 and 300 seconds. |
|
|
config dns agents <agentname>
timeout
Establishes the time that elapses during which the NCA waits for metrics from the specified agent before assuming the agent to be dead. The default value is 15 seconds.
Syntax:
config dns agents <agentname> timeout <seconds>
where:
agentname is the name of the agent whose metrics gathering timeout interval you wish to set.
seconds is an integer between 1 and 300 seconds.
Config DNS Agents Commands
100