Intel 7190 Configuring Other Snmp Parameters, Config sys snmp info Config sys snmp port port

C H A P T E R 7 Configuring Other SNMP Parameters

Configuring

Other SNMP

Parameters

This command causes traps to be sent to IP address 209.218.240.5, and causes the 7190 SNMP agent to put the community string NOC1 in the trap.

The following CLI commands are used to display and configure general SNMP parameters:

config sys snmp info

config sys snmp port <port>

config sys snmp sysContact <string> config sys snmp sysName <string> config sys snmp sysLocation <string>

config sys snmp auto-topology [enabledisable]

SNMP port is the UDP port used by the 7190 SNMP to listen for SNMP requests. By default, the SNMP port is 161. The SNMP port can be changed to a number between 5020 and 65535, or left at 161.

sysContact, sysName and sysLocation correspond to the MIB variables of the same name in MIB-II.sysContact is the name of the administrator of this 7190. By default, sysContact is null. sysName is the name of the 7190. By default, sysName contains the hostname of the 7190. sysLocation indicates where the 7190 is physically located. By default, sysLocation is null.

Support for Nortel Auto-topology protocol is enabled with auto- topology. By default, auto-topologyis disabled. When enabled, the Auto-topology protocol automatically executes whenever SNMP runs.

143