Useful Information

Error messages

Display message

Base no power or

No link. Re-connect base AC adaptor.

Busy

Check tel line1

Check tel line2

Error!!

Failed

Invalid

Requires subscription to Caller ID.

Use rechargeable battery.

Cause/solution

R The handset has lost communication with the base unit. Move closer to the base unit and try again.

R Unplug the base unit’s AC adaptor to reset the unit. Reconnect the adaptor and try again.

R The handset’s registration may have been canceled. Re-register the handset (page 46).

R No cellular phone is paired to the base unit. Pair a cellular phone (page 18).

R The called unit is in use.

R Other units are in use and the system is busy. Try again later. R The handset you are using is too far from the base unit. Move

closer and try again.

R The supplied telephone line cord has not been connected yet or not connected properly. Check the connections (page 9).

R If you use the unit as a single-line telephone only, erase the message as follows:

To erase “Check tel line1”, press MMENUN. a #189 To erase “Check tel line2”, press MMENUN. a #190 When a power failure occurs, the message is displayed again. Erase again as above.

R Recording was too short. Try again.

R Someone is using a cellular line or headset. Try again later.

R The phonebook copy is incomplete (page 50). The cellular phone is disconnected from the base unit. Make sure that other Bluetooth devices are not connected to the cellular phone, and try again.

R Although the unit tried to connect to the cellular phone or headset, the connection has been failed.

Someone is using a cellular line or headset. Try again later.

Make sure that the cellular phone or headset is not connected to other Bluetooth devices.

R There is no handset registered to the base unit matching the handset number you entered.

R The handset is not registered to the base unit. Register the handset (page 46).

R You must subscribe to a Caller ID service. Once you receive caller information after subscribing to a Caller ID service, this message will not be displayed.

R A wrong type of battery such as Alkaline or Manganese was inserted. Use only the rechargeable Ni-MH batteries noted on page 4, 6.

64

For assistance, please visit http://www.panasonic.com/help

TG954x(en)_0628_ver031.pdf 64

2013/06/28 12:35:33

Page 64
Image 64
Panasonic KX-TG9542, KX-TG9541 operating instructions Error messages, Display message, Base no power or, Cause/solution