Panasonic KX-TG9542, KX-TG9541 Operating a Bluetooth wireless headset using a landline

Using Bluetooth Devices

Handset / Base unit

1Your headset:

Set your headset to pairing mode.

R Refer to the headset operating instructions.

2MMENUN#621

3If your headset PIN is “0000”, go to step 4.

If your headset PIN is other than “0000”, press MCLEARN, then enter your headset PIN. R Typically, default PIN is “0000”. Refer to

the headset operating instructions.

4Press MOKN, then wait until a long beep sounds.

5Proceed with the operation for your unit. Handset: MOFFN

Base unit: MEXITN

R When the HEADSET indicator on the base unit lights up, the headset is available for use.

Connecting/disconnecting a headset

If you cannot connect the headset and base unit using the headset, you can connect using the unit. To use your headset with another Bluetooth device such as a cellular phone, you may need to disconnect it from the base unit.

Important:

R Make sure that the headset is turned on.

Handset

1To connect/disconnect: MMENUN#622

R A long beep sounds.

2MOFFN

Base unit

To connect:

Press MHEADSETN.

To disconnect:

Press and hold MHEADSETN until a long beep sounds.

Unpairing a headset

You can cancel a pairing of the headset that is stored to the base unit.

Handset / Base unit

1MMENUN#612

2MbN: “Yes” a MSELECTN

R When the headset is unpaired, the HEADSET indicator on the base unit is turned off.

3Proceed with the operation for your unit. Handset: MOFFN

Base unit: MEXITN

Operating a Bluetooth wireless headset using a landline

Important:

R Refer to your headset operating instructions for headset operations.

Answering landline calls with your headset

To answer a landline call, turn on your headset referring to your headset operating instructions. When you finish talking, turn off your headset referring to your headset operating instructions.

Note:

R If you cannot hang up the call using your headset, press MZN on the base unit 2 times.

Switching between the base unit and your headset

You can switch between the base unit and your headset:

–during a landline call with the base unit speakerphone.

–during an intercom call between the base unit and handset.

–while listening to messages recorded on the base unit answering system.

n To switch to your headset:

Press MHEADSETN on the base unit.

n To switch to the base unit: Press MZN on the base unit.

Call sharing between your headset and the handset

Important:

R To activate this feature, you should set call sharing mode to on beforehand (page 42).

n While the handset is on a landline call:

To join the conversation with your headset, turn on the headset referring to your headset operating instructions.

52 For assistance, please visit http://www.panasonic.com/help

TG954x(en)_0628_ver031.pdf 52

2013/06/28 12:35:32