Reference Information
Conexant AT Commands (Advanced Users Only) (Continued)
Command | (Conexant) |
|
|
+MR=0 | Disable reporting of modulation connection. |
|
|
+MR=1 | Enable reporting of modulation connection (+MCR: and +MRR: |
| are transmitted) (default). |
|
|
+MR=2 | Enable reporting of modulation connection (+MCR: and Receive |
| Rate Only: are transmitted). |
+MS=a,b,c, Select modulation (b, c, d, e, and f are optional).
d,e,f ■ a is the carrier (allowable rates in parentheses):
B103 (300), B212 (1200 Rx/75 Tx or 75 Rx/1200 Tx), V21 (300), V22 (1200), V22B (1200/2400), V23C (1200), V32(4800/9600), V32B
V92 (downstream:
upstream:
■b is automode: 0=disabled, 1=enabled (default).
■c is minimum transmit (Tx) rate (bps).
■d is maximum transmit rate (bps).
■e is minimum receive (Rx) rate.
■f is maximum receive rate (bps).
+WS=n | Set PDC mode: 1=disable (default), 20=enable. |
ECC Commands
Command | (Conexant) |
|
|
%Cn | Set data compression: 0=disable, 1=enable V.42 bis and |
| MNP 5, 2=enable V.42 bis and MNP 5, 3=enable V.42 bis |
| and MNP 5 (default). |
+EB=a,b,c Select break handling (b and c are optional):
■a=0 break is ignored.
■b=0 transmitted V.42
■c=0 break is not delivered to DTE.
+EFCS=0 Select
Reference Guide |