Reference Information
Conexant AT Commands (Advanced Users Only) (Continued)
Command (Conexant)
+PSS=n | 0=modems decide whether to use short startup procedures, |
| 2=use full startup procedures on all subsequent connections. |
|
|
+VCID=n | Set caller ID reporting: 0=disable (default), 1=enable with |
| formatted presentation, 2=enable with unformatted |
| presentation. |
|
|
+VRID=n | Report caller ID: 0=use formatted presentation, 1=use |
| unformatted presentation. |
|
|
Use full startup procedures on next connection, then select | |
| startup procedure defined by+PQC. |
|
|
0=do not allow modem to save generated | |
| 1=allow (default) |
|
|
&Cn | Set RLSD: 0=always on, 1=follow carrier state (default). |
|
|
&Dn | 0=ignore DTR; 1=upon |
| command state and issue OK result code; call remains |
| connected; 2=upon |
| untransmitted data according to +ETBM. |
|
|
&En | 0=disable line quality monitor, |
| renegotiation;1=enable line quality monitor, |
| |
|
|
&F0 | Restore factory configuration. |
|
|
&Gn | Included for compatibility only; no effect (returns OK). |
|
|
&Kn | Set DTE/DCE flow control: 0=disable, 3=enable RTS/CTS |
| DTE/DCE flow control (default), 4=enable XON/XOFF |
| DTE/DCE flow control, 5 and 6 included for compatibility only |
| (no effect, returns OK). |
|
|
&Mn | Included for compatibility only; no effect (returns result code). |
|
|
&Pn | Set pulse dial (pps) with make/break: 0=10 pps with |
| make/break (default), 1=10 pps with |
| 2=20 pps with |
| make/break. |
|
|
&Q5 | Select asynchronous operation in error correction mode. |
|
|
&Qn | |
| (speed buffering). |
Reference Guide |