Reference Information
Voice Commands
Command (Conexant)
+FCLASS=8 Select voice mode.
+VDR=a,b Set report ring cadence and timing of RING event code:
■a=0 disables ring cadence reporting, a=1 enables.
■b sets report content: 0=DROF and DRON messages only.
+VDT=a,b | Set report control tone cadence: |
| ■ a=0 disables ring cadence reporting, a=1 enables. |
| ■ b=0 reports CPOF and CPON messages only. |
|
|
+VDX=a | Select speakerphone |
|
|
+VGM=n | Set microphone gain of speakerphone function (0 to 255). |
|
|
+VGR=n | Set gain for received voice samples (0 to 255). |
|
|
+VGS=n | Set speaker gain of speakerphone function (0 to 255). |
|
|
+VGT=n | Set volume (120 to 135). |
|
|
+VIP | Initialize all voice parameters to defaults. |
|
|
+VIT=n | Set initial value for DTE/modem inactivity timer (0 to 255 sec). |
|
|
+VLS=n | Select sources/destinations for analog data. |
|
|
+VNH=n | Set automatic hangups: 0=enable, 1=disable, 2=disable |
| automatic hangups in |
|
|
+VPR=n | Set DTE/modem interface rate (0=autobaud). |
|
|
+VRA=n | Set delay between ringbacks before modem assumes remote |
| station is off hook (0 to 255 × 0.1 sec). |
|
|
+VRN=n | Set delay between ringbacks before modem assumes remote |
| station is off hook (0 to 60 sec). |
|
|
+VRXn | Start voice reception: 0=start without periodic tone production, |
| 1=start with periodic tone production. |
|
|
+VSD=a,b | Set silence detection sensitivity and required period of silence |
| before modem reports silence at end of voice receive. |
|
|
+VSM=a,b, | Set voice and silence compression methods, and voice |
c,d | sampling rate. |
Reference Guide |