Reference Information
Conexant AT Commands (Advanced Users Only) (Continued)
Command | (Conexant) |
|
|
On | 0=go online, 1=go online and initiate retrain sequence. |
|
|
P | Force pulse dialing. |
|
|
Qn | 0=enable result codes to DTE (default), 1=disable. |
|
|
Sn | Select |
|
|
Sn=v | Set default |
|
|
T | Force DTMF dialing. |
|
|
Vn | Report result codes: 0=short form (terse), 1=long form |
| (verbose) (default). |
|
|
W0 | Report DTE speed (default). |
|
|
W1 | Report line speed, error correction protocol, and DTE speed. |
|
|
W2 | Report DCE speed. |
|
|
W3 | Report DCE speed and error correction protocol. |
|
|
X0 | Report CONNECT result code on connecting. Dial tone and |
| busy detection not reported. |
|
|
X1 | Report CONNECT <text> result code on connecting. Dial tone |
| and busy detection not reported. |
|
|
X2 | Report CONNECT <text> result code on connecting. Dial tone |
| and busy detection not reported. |
|
|
X3 | Report CONNECT <text> result code on connecting. Dial tone |
| not reported, busy signal reported if detected. |
|
|
X4 | Report CONNECT <text> result code on connecting. Dial tone |
| and busy signal reported if detected (default). |
ZReset to default configuration.
+DR: a | Select error control protocol: NONE=no data compression, |
| V42B=42 bis in both directions, ALT=MNP 5 compression. |
|
|
+DR=n | 0=disables extended format “+DR:” intermediate result code, |
| 1=enables. |
Reference Guide |