Lexicon RT-20 REMOTE CONTROL OVERVIEW

RT-20 Universal Disc Player Basic Operation

2-13

REMOTE CONTROL OVERVIEW

The RT-20 remote control provides full operation of the RT-20, exe-

cuting functions such as menu navigation that are not available

from the front panel. The Command Matrix on page 2-14 to 2-18

describes the commands remote control buttons execute.

The bulleted items that begin below describe factors that can

improve or impede remote control operation. You should observe

these items and the battery installation instructions on page 1-9

before operating the remote control.

• If the RT-20 is not using the IR IN connector, the remote control

must be in line-of-sight with the front panel display remote

control sensor. Eliminate obstructions between the remote control

and the remote control sensor. The remote control can become

unreliable if strong sunlight or fluorescent light is shining on the

remote control sensor.

• For optimal performance, position the remote control at a 30

degree angle no more than 17 feet (5m) from the RT-20 as

shown below. If the RT-20 is placed inside a glass cabinet,

smoked glass will reduce the remote control range.

• Remote controls for different components can interfere with

one another. Avoid using remote controls for different compo-

nents at the same time.

• The two AA batteries should be replaced as needed. See

“REMOTE CONTROL BATTERY INSTALLATION” on page 1-9 for

more information.

This remote control supports two remote codes: DVD2 and DVD1.

The default is DVD2.

Be sure to set the REMOT CODE on the Front Panel Display menu

to the same setting as the remote control. The Front Panel Display

menu remote code default setting is DVD2.

To check which remote control code is currently set, hold down

both the STOP and PAUSE buttons. The current code will be dis-

played on the RT-20 front panel display.

• To set the remote control to DVD1, hold down the remote con-

trol STOP button and number 1 button for at least 5 seconds.

• To set the remote control back to DVD2, hold down both the

STOP button and the 2 number button on the remote control

for at least 5 seconds.

See “REMOT_CODE” on page 3-34 for more information.

The matrix that begins on the next page describes the commands

remote control buttons execute. The numbers in the RT-20 remote

control illustrations beginning on the next page correspond to the

numbered items in the Command Matrix.