RT-20 Universal Disc Player Setup
3-11
SPEAKER SIZE
Opens the Speaker Setting screens, which can be used to set
speaker sizes when the RT-20 is using the 5.1-channel analog audio
output connectors.
Note:
• Speaker size settings have no effect when the RT-20 is using the
2-channel analog audio output connectors or digital audio output
connectors.
• RT-20 speaker size settings do not need to be configured when the
RT-20 is connected to an associated component such as the MC-12
Digital Controller or the RV-8 Digital Receiver, which allows speaker
settings to be configured for analog audio sources. The associated
component must not be using analog audio connections in bypass.
SETTING SPEAKER SIZES
Use the Speaker Size screen to set speaker sizes and crossover
points for the front, center, surround, and subwoofer speakers.
Refer to the manufacturer’s owner’s manuals to determine the low-
frequency response of each speaker.
To set speaker sizes:
1. When the Speaker Size screen opens, press the remote control
and buttons to highlight the desired parameter.
2. When the desired parameter is highlighted, press the and
buttons to cycle through available settings.
• Selecting Initial will cause all settings to return to their
default.
• For DVD-A and DTS-CD, if any of the C, LS or RS speakers
are set to OFF, audio is automatically downmixed to stereo.
Select Small, if the low-frequency response of the associated
speaker cannot be determined, and the main cone of the associ-
ated speaker is less than 6 inches (12cm). Select Large if the main
cone of the associated speaker is greater than 6 inches (12cm).
The LFE (sub) parameter determines the presence or absence of a
subwoofer. Select On if a subwoofer is present. The RT-20 will pass
subwoofer signals (LFE) to the Sub analog audio output connector.