45
En
11 Controlling Other Equipment
6 Point the remotes towards each other, about 2-5 cm (1-2 inches)
apart.
7 Press the button on the other component’s remote for the
command you want to program.
The LED on this system’s remote will go out and then blink twice when the command
has been learned.
• If the LED doesn’t start blinking, try varying the distance between the remotes, then
press the button again.
• Some commands from other remote controls cannot be learned, but in most cases
the remotes just need to be moved closer together or farther apart.
• If the LED starts to blink slowly, it may mean that no more commands can be learnt.
If it is necessary to learn another command, first delete another learnt command—
see the following page.
8 Program additional commands for the same component as
required.
Repeat steps 5 through 7.
9 Program commands for other components as required.
Repeat steps 4 through 7.
10 When you’re done, press REMOTE SETUP to exit Learning Setup
mode.

Learning directly from other remote controls

If preset codes are not available for your component(s), or the available preset codes do
not work, you can use this method to teach the remote each command separately.
You can also use this operation to program additional commands for a component not
covered in the preset codes.
1 Press and hold REMOTE SETUP for three seconds.
The LED at the top of the remote blinks twice.
2 Press the MULTI CONTROL button for the component you want
to control.
For example, press VIDEO V-1 to program a command from a VCR connected to the
Video 1 inputs/outputs.
3 Using the number buttons, enter 975.
The LED flashes rapidly to indicate that the remote is in Learning Setup mode and ready
to learn new commands from another remote.
• The remote will exit Learning Setup after 10 seconds if no commands are entered.
• To cancel Learning Setup here, press REMOTE SETUP.
4 Press the MULTI CONTROL button again for the component you
want to control.
5 Press the button on this system’s remote that you want to learn a
new command.
For example, press 3.
The illustration left shows the buttons that can be used to learn commands.