64
En
13 Additional Information
The disc is ejected automatically after loading.
• Dirty or damaged disc.
See page 57 for disc care information.
• Disc not seated properly in the disc guide.
Align the disc properly.
• Incompatible region number.
If the region number on a DVD-video disc does not
match the number on the DVD tuner, the disc cannot
be used (page 6).
• Condensation inside the unit.
Allow time for condensation to evaporate. Avoid using
the player near an air-conditioning unit.
Playback is not possible.
• Disc is loaded upside down.
Reload the disc with the label side face up.
• In the case of CD-R and CD-RW discs, make sure that the
recording has been finalized following the procedures in
the manual supplied with the recording component.
mark appears on screen.
• The operation is prohibited by the system.
mark appears on screen.
• The selected function does not operate for that disc.
When making changes in the Setup OSD
menus, is displayed.
• There is a CD or Video CD loaded and the setting that was
changed applies only to DVD discs.
The settings will take effect next time a DVD is loaded.
Picture playback stops and the operation
buttons cannot be used.
Press 7, then start playback again (3). Switch the
power off once, then on again using the front panel
STANDBY/ON switch.
DVD/CD/Video CD
New settings made in the Setup screen menus
while a disc is playing are ineffective.
• Some settings can be changed while a disc is playing, but
are not effective until the disc is stopped then restarted.
This is not a malfunction.
Make the same setting when the disc is stopped.
Press 7, then restart playback (3). Note that making
settings in the Setup screen menus may cancel the
RESUME function.
Settings are canceled.
• When the power is cut due to power failure or by
unplugging the power cord, settings will be canceled.
No picture/No color.
• Incorrect video connections.
Check that connections are correct and that plugs are
inserted fully.
• TV/monitor settings are incorrect.
Check the instruction manual of the TV/monitor.
Screen is stretched or aspect does not change.
• The TV Screen setting in the Setup menu is incorrect.
Set the TV Screen option to match the TV/monitor
you're using (page 35).
DVD/CD/Video CD

Troubleshooting

Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances
being used. If the trouble cannot be rectified after checking the items below, ask your nearest Pioneer authorized service center or
your dealer to carry out repair work.