Chapter 2 Configuring Your Voice Gateway Using the setup Command
Using the setup Command
Step 4 Determine the addressing plan for each network protocol.
Using the setup Command
The setup command is displayed in your PC terminal emulation program window.
Note If you make a mistake while using the setup command, you can exit and run the command again. Press
Procedure
Step 1 Plug in the external power supply.
The system begins to display messages in your terminal emulation program window.
Caution The voice gateway does not enter setup mode during the initial configuration. During initial configuration, the voice gateway boots up in
Caution Do not press any keys on the keyboard until the messages stop. The system interprets any keys pressed during this time as the first command typed when the messages stop, which might cause the voice gateway to power off and start over. It takes a few minutes for the messages to stop.
The messages look similar to the following example.
System configuration has been modified. Save? [yes/no]: n
Proceed with reload? [confirm]
*Apr 21 14:23:38.051:
System Bootstrap, Version 12.4(20080415:092610)
VG202 platform with 131072 Kbytes of main memory
Upgrade ROMMON initialized
program load complete, entry point: 0x80020000, size: 0x1437d40 Self decompressing the image:
##########################################################################################
##########################################################################################
################################# [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph
(c)of the Commercial Computer Software - Restricted Rights clause at FAR sec.
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Software Configuration Guide
|
| |
|