Chapter 2 Configuring Your Voice Gateway Using the setup Command
Using the setup Command
Enter hostname [VG]: VG204
The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration.
Step 5 Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the configuration:
The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration.
Enter enable secret: cisco
Step 6 Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure) and can be seen when viewing the configuration:
The enable password is used when you do not specify an
enable secret password, with some older software versions, and some boot images.
Enter enable password: cisco
%Please choose a password that is different from the enable secret Enter enable password: cisco
Step 7 Enter the virtual terminal password, which prevents unauthenticated access to the voice gateway through ports other than the console port:
The virtual terminal password is used to protect access to the VG over a network interface. Enter virtual terminal password: cisco Configure SNMP Network Management? [yes]: n
Configure IP? [yes]:
Configure RIP routing? [yes]: n Configure bridging? [no]:
Step 8 Respond to the following prompts as appropriate for your network:
Do you want to configure FastEthernet0/0 interface? [yes]:
Use the 100
Operate in
Configure IP on this interface? [yes]:
IP address for this interface: 9.13.38.150
Subnet mask for this interface [255.0.0.0] : 255.255.255.0
Class A network is 9.0.0.0, 24 subnet bits; mask is /24
Do you want to configure FastEthernet0/1 interface? [yes]: n
Would you like to go through AutoSecure configuration? [yes]: n
AutoSecure dialog can be started later using "auto secure" CLI
The following configuration command script was created:
hostname
enable secret 5 $1$Y0VQ$D8qM6vS3qId.BP3w.GjlE. enable password cisco
line vty 0 4 password cisco no
!
ip routing no bridge 1
!
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Software Configuration Guide
|
| |
|
