C H A P T E R 2
Configuring Your Voice Gateway Using the setup Command
This chapter describes how to use the setup command to configure your voice gateway. The setup command prompts you to enter information needed to start a voice gateway functioning quickly. The facility steps you through a basic configuration, including LAN interfaces.
•About Configuring Your Voice Gateway, page
•Preparing to Configure Your Cisco Voice Gateway, page
•Using the setup Command, page
•Completing the Configuration, page
About Configuring Your Voice Gateway
The Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM voice gateways ship with a default configuration. During the first boot up, the voice gateways do not enter setup mode and are configured through
If you prefer to configure the voice gateway manually or if you wish to configure a module or interface that is not included in the setup command, proceed to “Chapter 3, “Configuring Your Voice Gateway Using the CLI,” for
If you prefer to configure the voice gateway using AutoInstall, see Using AutoInstall to Remotely Configure Cisco Networking Devices.
Preparing to Configure Your Cisco Voice Gateway
Procedure
Step 1 Set up the hardware as described in the Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide.
Step 2 Configure your PC terminal emulation program for 9600 baud, 8 data bits, no parity, and 1 stop bit. Step 3 Determine which network protocols you support.
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Software Configuration Guide
|
| ||
|
|