Cisco Systems WS-X4516 specifications Features of the Supervisor Engine Front Panel, Led

Supervisor Engine V

•Supervisor engine redundancy between primary and standby supervisor engines in Catalyst 4510R and Catalyst 4507R

•802.1Q tunneling

•Storm control in hardware

•Support for the Catalyst 4500 Series NetFlow Services Card (WS-F4531).

When the Supervisor Engine V is used in a Catalyst 4510R, slot 10 is a flex-slot intended for use with the 2-port Gigabit Ethernet switching module (WS-X4302-GB) or the Access Gateway Module (WS-X4604-GWY) only.

Features of the Supervisor Engine Front Panel

The following sections describe the LEDs, connectors, and switches on the Catalyst 4500 series Supervisor Engine V:

•LEDs, page 9

•Gigabit Ethernet Uplink Ports, page 10

•Ethernet Management Port, page 10

•Console Port, page 10

•Reset Button, page 10

•Flash Port, page 11

LEDs

Table 1 describes the LEDs on the supervisor engine front panel.

Table 1	Supervisor Engine LEDs (WS-X4516)
LED		LED Status	Description
STATUS			Indicates the results of a series of self-tests.
		Green	All diagnostic tests passed.
		Red	A test failed.
		Orange	System boot or diagnostic test is in progress.
		Off	Module is disabled.
UTILIZATION		Green 1–100%	If the switch is operational, this display indicates the current
			traffic load over the backplane (as an approximate percentage).
Link			Indicates the status of the 10/100BASE-T Ethernet management
			port or uplink ports.
		Green	The link is operational.
		Orange	The link is disabled by user.
		Flashing orange	The power-on self-test indicates a faulty port.
		Off	No signal is detected or there is a link configuration failure.

Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V

78-15590-02 9