42-23
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 42 Configuring IP Unicast Routing Configuring RIP
To turn off the RIP routing process, use the no router rip global configuration command.
To display the parameters and current state of the active routing protocol process, use the show ip
protocols privileged EXEC command. Use the show ip rip database privileged EXEC command to
display summary address entries in the RIP database.
Configuring RIP Authentication
RIP Version 1 does not support authentication. If you are sending and receiving RIP Version 2 packets,
you can enable RIP authentication on an interface. The key chain specifies \the set of keys that can be
used on the interface. If a key chain is not configured, no authentication is performed, not even the
default. Therefore, you must also perform the tasks in the “Managing Authentication Keys” section on
page 42-103.
The switch supports two modes of authentication on interfaces for which RIP authentication is enabled:
plain text and MD5. The default is plain text.
Beginning in privileged EXEC mode, follow these steps to configure RIP authentication on an interface:
To restore clear text authentication, use the no ip rip authentication mode interface configuration
command. To prevent authentication, use the no ip rip authentication key-chain interface
configuration command.
Configuring Summary Addresses and Split Horizon
Routers connected to broadcast-type IP networks and using distance-vector routing protocols normally
use the split-horizon mechanism to reduce the possibility of routing loops. Split horizon blocks
information about routes from being advertised by a router on any interface from which that information
originated. This feature usually optimizes communication among multiple routers, especially when links
are broken.
Note In general, disabling split horizon is not recommended unless you are certain that your application
requires it to properly advertise routes.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Enter interface configuration mode, and specify the
interface to configure.
Step 3 ip rip authentication key-chain name-of-chain Enable RIP authentication.
Step 4 ip rip authentication mode [text | md5}Configure the interface to use plain text authentication (the
default) or MD5 digest authentication.
Step 5 end Return to privileged EXEC mode.
Step 6 show running-config interface [interface-id]Verify your entries.
Step 7 copy running-config startup-config (Optional) Save your entries in the configuration file.