11-24
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 11 Configuring IEEE 802.1x Port-Based Authentication
Understanding IEEE 802.1x Port-Based Authentication
IEEE 802.1x Authentication with Port Security
You can configure an IEEE 802.1x port with port security in either single-host or multiple-hosts mode.
(You also must configure port security on the port by using the switchport port-security interface
configuration command.) When you enable port security and IEEE 802.1x authentication on a port, IEEE
802.1x authentication authenticates the port, and port security manages network access for all MAC
addresses, including that of the client. You can then limit the number or group of clients that can access
the network through an IEEE 802.1x port.
These are some examples of the interaction between IEEE 802.1x authentication and port security on the
switch:
• When a client is authenticated, and the port security table is not full, the client MAC address is added
to the port security list of secure hosts. The port then proceeds to come up normally.
When a client is authenticated and manually configured for port security, it is guaranteed an entry
in the secure host table (unless port security static aging has been enabled).
A security violation occurs if the client is authenticated, but the port security table is full. This can
happen if the maximum number of secure hosts has been statically configured or if the client ages
out of the secure host table. If the client address is aged, its place in the secure host table can be
taken by another host.
If the security violation is caused by the first authenticated host, the port becomes error-disabled and
immediately shuts down.
The port security violation modes determine the action for security violations. For more
information, see the “Security Violations” section on page 28-10.
• When you manually remove an IEEE 802.1x client address from the port security table by using the
no switchport port-security mac-address mac-address interface configuration command, you
should re-authenticate the IEEE 802.1x client by using the dot1x re-authenticate interface
interface-id privileged EXEC command.
• When an IEEE 802.1x client logs off, the port changes to an unauthenticated state, and all dynamic
entries in the secure host table are cleared, including the entry for the client. Normal authentication
then takes place.
• If the port is administratively shut down, the port becomes unauthenticated, and all dynamic entries
are removed from the secure host table.
• Port security and a voice VLAN can be configured simultaneously on an IEEE 802.1x port that is in
either single-host or multiple-hosts mode. Port security applies to both the voice VLAN identifier
(VVID) and the port VLAN identifier (PVID).
You can configure the authentication violation or dot1x violation-mode interface configuration com-
mand so that a port shuts down, generates a syslog error, or discards packets from a new device when it
connects to an IEEE 802.1x-enabled port or when the maximum number of allowed devices have been
authenticated. For more information see the “Maximum Number of Allowed Devices Per Port” section
on page 11-38 and the command reference for this release.
For more information about enabling port security on your switch, see the “Configuring Port Security”
section on page 28-8.
IEEE 802.1x Authentication with Wake-on-LAN
The IEEE 802.1x authentication with wake-on-LAN (WoL) feature allows dormant PCs to be powered
when the switch receives a specific Ethernet frame, known as the magic packet. You can use this feature
in environments where administrators need to connect to systems that have been powered down.