48-7
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 48 Configuring IP Multicast Routing Understanding Cisco’s Implementation of IP Multicast Routing
Auto-RP
This proprietary feature eliminates the need to manually configure the RP information in every router
and multilayer switch in the network. For auto-RP to work, you configure a Cisco router or multilayer
switch as the mapping agent. It uses IP multicast to learn which routers or switches in the network are
possible candidate RPs to receive candidate RP announcements. Candidate RPs periodically send
multicast RP-announce messages to a particular group or group range to announce their availability.
Mapping agents listen to these candidate RP announcements and use the information to create entries in
their Group-to-RP mapping caches. Only one mapping cache entry is created for any Group-to-RP range
received, even if multiple candidate RPs are sending RP announcements for the same range. As the
RP-announce messages arrive, the mapping agent selects the router or switch with the highest IP address
as the active RP and stores this RP address in the Group-to-RP mapping cache.
Mapping agents periodically multicast the contents of their Group-to-RP mapping caches. Thus, all
routers and switches automatically discover which RP to use for the groups that they support. If a router
or switch fails to receive RP-discovery messages and the Group-to-RP mapping information expires, it
changes to a statically configured RP that was defined with the ip pim rp-address global configuration
command. If no statically configured RP exists, the router or switch changes the group to dense-mode
operation.
Multiple RPs serve different group ranges or serve as hot backups of each other.
Bootstrap Router
PIMv2 BSR is another method to distribute group-to-RP mapping information to all PIM routers and
multilayer switches in the network. It eliminates the need to manually configure RP information in every
router and switch in the network. However, instead of using IP multicast to distribute group-to-RP
mapping information, BSR uses hop-by-hop flooding of special BSR messages to distribute the mapping
information.
The BSR is elected from a set of candidate routers and switches in the domain that have been configured
to function as BSRs. The election mechanism is similar to the root-bridge election mechanism used in
bridged LANs. The BSR election is based on the BSR priority of the device contained in the BSR
messages that are sent hop-by-hop through the network. Each BSR device examines the message and
forwards out all interfaces only the message that has either a higher BSR priority than its BSR priority
or the same BSR priority, but with a higher BSR IP address. Using this method, the BSR is elected.
The elected BSR sends BSR messages with a TTL of 1. Neighboring PIMv2 routers or multilayer
switches receive the BSR message and multicast it out all other interfaces (except the one on which it
was received) with a TTL of 1. In this way, BSR messages travel hop-by-hop throughout the PIM
domain. Because BSR messages contain the IP address of the current BSR, the flooding mechanism
enables candidate RPs to automatically learn which device is the elected BSR.
Candidate RPs send candidate RP advertisements showing the group range for which they are
responsible to the BSR, which stores this information in its local candidate-RP cache. The BSR
periodically advertises the contents of this cache in BSR messages to all other PIM devices in the
domain. These messages travel hop-by-hop through the network to all routers and switches, which store
the RP information in the BSR message in their local RP cache. The routers and switches select the same
RP for a given group because they all use a common RP hashing algorithm.