Cisco Systems 3560X, 3750-X, WSC3750X48TS Editing Commands through Keystrokes

2-7
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 2 Using the Command-Line Interface Using Editing Features
To re-enable the enhanced editing mode for the current terminal session, enter this command in
privileged EXEC mode:
Switch# terminal editing
To reconfigure a specific line to have enhanced editing mode, enter this command in line configuration
mode:
Switch(config-line)# editing
Editing Commands through Keystrokes
Table 2-5 shows the keystrokes that you need to edit command lines. These keystrokes are optional.
Tab le 2-5 Editing Commands through Keystrokes
Capability Keystroke1Purpose
Move around the command line to
make changes or corrections.
Press Ctrl-B, or press the
left arrow key.
Move the cursor back one character.
Press Ctrl-F, or press the
right arrow key.
Move the cursor forward one character.
Press Ctrl-A.Move the cursor to the beginning of the command line.
Press Ctrl-E.Move the cursor to the end of the command line.
Press Esc B.Move the cursor back one word.
Press Esc F.Move the cursor forward one word.
Press Ctrl-T.Transpose the character to the left of the cursor with the
character located at the cursor.
Recall commands from the buffer and
paste them in the command line. The
switch provides a buffer with the last
ten items that you deleted.
Press Ctrl-Y.Recall the most recent entry in the buffer.
Press Esc Y.Recall the next buffer entry.
The buffer contains only the last 10 items that you have
deleted or cut. If you press Esc Y more than ten times, you
cycle to the first buffer entry.
Delete entries if you make a mistake
or change your mind.
Press the Delete or
Backspace key.
Erase the character to the left of the cursor.
Press Ctrl-D.Delete the character at the cursor.
Press Ctrl-K.Delete all characters from the cursor to the end of the
command line.
Press Ctrl-U or Ctrl-X.Delete all characters from the cursor to the beginning of
the command line.
Press Ctrl-W.Delete the word to the left of the cursor.
Press Esc D.Delete from the cursor to the end of the word.
Capitalize or lowercase words or
capitalize a set of letters.
Press Esc C.Capitalize at the cursor.