Printer Adjustments
Sensor Adjustments
Adjusting the Reflective sensor
1.Open the printhead and the sensor arm, then align the position of the sensor marker of the bottom sensor is at the center of the black mark on the media.
Media | Black mark |
|
Bottom sensor
Black mark
Reflective sensor marker
2.Select the reflective sensor.
3.With the reflective sensor selected, install the label media so that it is between the platen roller and the media sensor.
(Be careful that black mark and media gap do not pass the media sensor.) Then close the sensor arm and the printhead.
Label
Black mark | Liner media |
Bottom sensor
4.If the PAUSE key is pressed and released while the MODE/ REPEAT key is pressed, PRINT LED goes off, the CONDITION LED switches from lit to rapid flashing, media feeding starts, and the sensor is automatically adjusted.
5.If automatic adjustment stops normally, the PRINT LED and CONDITION LED return to their original status. If it does not stop normally (adjustment impossible), the CONDITION LED and ERROR LED flash.
6.If the STOP key is pushed, it exits sensor adjustment mode.
41