3Printer Adjustments

Sensor Adjustments

The sensing level of both the transparent (see thru) and reflective sensors is adjusted separately and independently. Firstly, the sensor type must be selected either using the VuePrint menu system or the Sensor Method Selection shown below. Then the adjustment and calibration of the sensor can be made.

Entering Sensor Adjustment Mode

1.Turn on the power while pushing the PAUSE key, FEED key, and STOP key simultaneously.

+ +

Power Switch

2.After the PRINT LED and CONDITION LED light up, release the keys to change the printer to sensor adjustment setting mode.

Media Setting (p.23)

Sensor Selection Method (Transparent ↔ Reflective)

 

To switch from transparent to reflective sensor, ensure the CONDITION LED

 

is lit then hold down the MODE/REPEAT key and then press the STOP key.

 

Each time you press the STOP key, you switch to back and forth between the

 

two sensor types.

 

If the transparent sensor is selected, the PRINT LED lights up and the buzzer

 

sounds once. If the reflective sensor is selected, the PRINT LED flashes

 

slowly and the buzzer sounds twice.

+

34