Troubleshooting
Indication | Check | Corrective action |
|
|
|
The printer is not | 3) Is the print head dirty? | 3) If it is dirty, remove the dirt with the |
printing neatly. | Is a label stuck to the head. | attached head cleaner. |
|
| If a label is stuck to the head, remove |
|
| it. |
|
| Note: Do not use a metal object to |
|
| remove a label stuck to the inside of |
|
| the printer. (This may damage the |
|
| print head.) If adhesive label material |
|
| is stuck to the print head, remove it |
|
| with a soft cloth soaked in ethyl |
|
| alcohol. |
|
|
|
| 4) Is the print head in the | 4) Adjust the offset of the print head |
| correct position for the | with the media thickness adjustment |
| media that is used? | dial. |
|
|
|
| 5) Is the printer’s head | 5) Adjust the print head pressure with |
| pressure balance correct for | the media width adjustment dial. |
| the width of the media that |
|
| is used? |
|
|
|
|
The printing position | 1) Is the media properly | 1) Correctly install the media. |
changes. | installed? |
|
|
|
|
| 2) Is the platen dirty? | 2) If it is dirty, clean it with ethyl alcohol. |
| Is it deformed? | If it is deformed, replace it. |
|
| Note: Consult with the dealer that |
|
| supplied the printer concerning the |
|
| replacement. |
|
|
|
| 3) Are the data contents and | 3) If an error message is displayed, check |
| the command signals from | the content of the software and the |
| the host appropriate? | communication status set by the host |
|
| computer. |
|
|
|
| 4) Are the menu values set | 4) Set the correct menu values using the |
| appropriately? | operating panel or the host computer. |
|
|
|
| 5) Are the sensitivities of the | 5) Set the media sensitivity to |
| media sensors appropriate | appropriate values. |
| for the media that is used? | If this does not solve the problem, |
|
| change the “Sensor level” that is set |
|
| in the “System setup.” |
|
|
|
41