Rear Connectors

Interface connector

Cash drawer

(Serial, parallel, etc.)

kick-out connector

Power connector (DC power supply type)

AC inlet

Interface board

USB connector

(AC power type)

mounting screws

 

●Interface connector (Serial, parallel, etc.)

Connects to the interface cable. A DIP switch is provided on the serial interface board.

●Cash drawer kick-out connector

Connects to the cable from the cash drawer.

●AC inlet (AC power type) Connects to the AC power cord.

●Power connector (DC power supply type) Connects to the cable from DC power source.

2.2Printer Cover Inside

●Paper feed roller

F e e d s p a p e r a s p a r t o f p r i n t mechanism.

●Paper-near-end sensor

Detects near paper end, change position in accordance with the outer diameter of paper core.

●Auto cutter

Cuts the paper with a command at the end of printing. Cutting method is selectable between partial cut and full cut with a command.

*Factory default of the memory SW4-8 is set to "Partial cut", so that a command will be ignored.

However, full cutting is set for the model supporting label.

●Manual cutter

Tears the paper by hand.

●Print (thermal) head

Prints characters and/or graphic data on thermal paper.

●Paper-end sensor

Stops printing when this sensor detects paper end.

Manual cutter

Paper-end sensor

Paper feed roller

Print (thermal) head

Auto cutter

Paper-near-end sensor

— 11 —