5.4 Selecting Paper Type *L, *M
Paper type selection is available by the combination of memory switches SW4- 4 and
1 Enter Selecting Paper Type mode.
1)Open the printer cover and remove paper. Pressing and holding the FEED button, turn the printer power ON. The POWER LED starts blinking.
2)Release the FEED button and then close the printer cover. Buzzer sounds and the paper type currently set is indicated by the LED on the operation panel.
2Select Paper Type.
Press the FEED button to match the paper type loaded to the LED indications in the table below. (Refer to the table below.)
|
|
| POWER LED | ERROR LED |
|
|
| ||
|
|
|
|
|
| Label | Green lit | (OFF) | |
|
|
|
| |
|
|
|
|
|
| Thermal paper roll | (OFF) | Red lit | |
|
|
|
| |
|
|
|
|
|
| Black Mark paper | Green lit | Red lit | |
|
|
|
|
|
|
|
|
|
|
3Save the selected Paper Type to the Printer.
Open and close the printer cover. By this operation, selected paper type is stored in the printer memory and the Selecting Paper Type mode is terminated. Since then, "P.Length Set" of Memory switch
When closing the printer cover during the setting a Black Mark paper or label paper in the printer, paper length is measured, and the result will be printed out.
*If Paper Detection error occurs at the measurement of paper length, the printer automatically enters Adjusting Paper Sensor mode. Adjust the sensor in accordance with
5.5 Adjusting Paper Sensor *L, *M
Before using Black Mark paper (BM paper) or label, adjust the Paper sensor. First, hold the lever at the upper end of the sensor adjustment control cover located at the left of the Power switch and press the lever down and toward the front to remove the cover from the printer.
As shown below, the most left one is a label paper sensor adjuster, the next is Black Mark paper sensor adjuster, and the right one is a level indicator LED. Adjust them in the following procedure.
— 32 —