(22) Generating specified Pulse (ESC p m n1 n2) Code : [1B]h + [70]h + m + n + n2
* {m = connector pin No. (See table below.)} {0 ≤ n1 ≤ FF}
{0 ≤ n2 ≤ FF} Data is described in Hex code. Signals specified by n1, n2 are output to Connector Pin m.
•Bit m (m0) means the followings.
m0
0
1
•ON time is considered as n1 x 2ms and OFF time as n2 x 2ms.
•When m is out of the defined range, n1, n2 are discarded, where no signals are output.
•Drive duty of Drawer is shown below:
| ON time |
| ≤ 0.2 |
| ON time + OFF time | ||
|
| ||
(Take OFF time as being 4 times or more longer than ON time.) | |||
(23) Selecting Character Code Table (ESC t n) | |||
Code : [1B]h + [74]h + n |
| ||
*{0 ≤ n ≤ 1} Data is described in Hex code. Selecting Page n on the character code table:
•"n" means the followings.
n (Hex)
0
1
• The initial value of n is specified by Jumper setting (J1 - J3).
32 | CITIZEN |
