4.6 Memory Switch Setting
<Memory Switch Initial Setting>
| Japan (910JPN) |
International character selection | Japanese |
Code page | |
Emulation | CBM910 |
Ack timing | After |
Valid | |
SEL/DESEL at power ON | SEL |
Busy signal clear timing | Standard |
Buffer Size (Serial I/F) | 2k bytes |
Memory switch can be changed by a command or by manual operation.
a)Change by command
Memory switch can be changed by a command. For details, refer to 8. Print Control Function.
When the printer receives the command, it outputs a BUSY signal and enters memory setting mode. After writing into memory switch, software resetting is carried out and the receive buffer/print buffer are cleared causing each set value to return to the initial value and then the contents of the memory switch(es) are reloaded.
b)Change by manual operation
Turn the printer power on with DIP switch No. 4 set to ON and by pressing and holding the SEL switch. The printer prints the information on the current memory switch setting and then enters the Change Setting mode.
In this case, the POWER lamp blinks at
Using the SEL switch and LF switch, choose one of the options for each setting item. Then memory switch can be set or changed. Setting items and options are printed each time the switch is pressed.
The SEL switch allows the option being printed to be determined as the set value for current setting item, advancing to the next option item. The LF switch allows the option currently being printed to be deselected among the same setting items and the next option item to be printed.
To fix the value set by the memory switch when the option item of the last setting items is selected, press the SEL switch. To restart setting from the first setting items, press the LF switch.
NOTE
Before turning the printer power on, restore the DIP switch No. 4 to the former position.
— 19 —
