(18)Change Memory Switch (ESC + “)” + 55 (H) + n1 + n2 + AA(H))
Entering this code allows the contents of the memory switch shown in the table below to be changed.
When the printer receives this code, it enters the BUSY mode.
After writing to memory switch, reset is carried out and the receive buffer/ print buffer is cleared and the initial value is restored and then the contents of the memory switch is reloaded.
n1 | Function | n2 | Content of Setting |
0 | Select international character set | 0~8 | See International Character Code Table. |
1 | Select code page. | 0~11, 253, | See Character Code Table Select |
|
| 254, 255 | Command. |
2 | Select 910/3110 emulation | 0 | 910 Emulation |
|
| 1 | 3110 Emulation |
3 | ACK timing *1 | 0 | Before |
|
| 1 | Center |
|
| 2 | After |
4 | Enable/Disable | 0 | Enable (Valid) |
|
| 1 | Disable (Invalid) |
5 | Online state at power on | 0 | Select (Online) |
|
| 1 | Deselect (Offline) |
6 | BUSY timing *1 | 0 | Standard |
|
| 1 | |
7 | Buffer Size (Serial I/F) | 0 | 2k bytes |
|
| 1 | 72 bytes |
*1: Setting is permitted only for parallel interface.
NOTE
When the set value is outside the specified range, writing to memory is not carried out.
— 46 —
