E
N
G
L
I
S
H 3.7 Ribbon Tension Adjustments (CLP 7201e, 7202e)
The CLP 7201e and 7202e feature an automatic ribbon tensioning system to keep
even tension during a print run.
If you recei ve a “Ribbon
Out” error message during
normal operation, you may
need to adjus t the
tensioning system.
With some specialist
ribbons and occasionally
with narrow width ribbons,
the base lev el of the ri bbon
tensioning system may
need to be adjusted.
Easy-to-slip ri bbo n a n d me di a
Set the feeding section tension adjuster to the
LOW position.
Especially-easy-to-slip ribbon and media
Should the “Ribbon Out” error still occur, set the
feeding secti on adjuster t o the SUPER LOW
position.
When ribbon is br oken during print ing
The ribbon ma y be broken if it is nar row in widt h
and printhead heat temperature is high. In that
case, set the mark on the feeding section to
SUPER LOW and set the mark on the windi ng
section to LOW by turning the adjus t-knob and
adjust-screw respectively.
Note: If the problem is still not resolved, please
contact our service personnel.