Citizen Systems iDP-562 user manual Control Code

iDP-562 User’s Manual

7. Control Code

Control codes are the same for 7 BIT DATA and 8 BIT DATA except SI & SO code.

7.1 SI & SO Code

Symbol		8 BIT DATA				7 BIT DATA
SI	Standard character designation (Same as US)					Designation of SI side character
SO	Enlarged character designation (Same as RS)					Designation of SO side character
7.2 Function Code
Symbol		Code				Function
		( Hexadecimal)
LF		0A		Feeds a new line after printing.
CR		0D		Feeds a new line after printing.
				You can select CR function in accordance with
				your computer's output. For details, refer to
				5.5 Setting the Preset Jumper.
RS		1E		Enhanced character designation.
				The designation is released with US code or line feed.
US		1F		Standard character designation.
FF		0C		Carries out from feed performance after printing.
DC1		11		Makes the printer SELECT (ON-LINE) state.
				Only this code can be accepted irrespective of
				DESELECT (OFF-LINE) state.
DC2		12		Red printing is specified / released.
				Designation / release (alternative) of red one line
				printing is possible with this code.
DC3		13		Makes the printer DESELECT (ON-LINE) state.
Symbol		Code			Function
		(Hexadecimal)
			Designation / release of reverse printing.
DC4		14	Designation / release (alternative) of reverse printing
			is possible with this code.
CAN		18	Clears the print data in the buffer.
			Al the previous input data is cleared with this code.
			Graphic print (correspondence with bit) mode designation.
*ESC + "K"		1B, 4B	It is not possible to print graphic mode
			and another character mode in one line.
ESC + "C"		1B, 43	Page length designation and paging action.
			Refer to 7.3.
ESC + "0"		1B, 4F	Paging is off
*ESC + "1"		1B, 31	2.75mm line spacing.
*ESC + "2"		1B, 32	5.5mm line spacing.
*Only for iDP562-RS and iDP562CN type.
CITIZEN			27