Citrix Systems 9.3 setup guide CompactFlash Card, Removing the Existing DC Power Supply

Chapter 1 Introduction to the Hardware Platforms

Figure 1-13.Removing the Existing DC Power Supply

2.Carefully remove the new power supply from its box.

3.On the back of the appliance, align the power supply with the power supply slot.

4.Insert the power supply into the slot while pressing the lever towards the handle. Apply firm pressure to insert the power supply firmly into the slot.

Figure 1-14.Inserting the Replacement DC Power Supply

5.When the power supply is completely inserted into its slot, release the lever.

6.Connect the power supply to a power source. If connecting all power supplies, plug separate power cords into the power supplies and connect them to separate wall sockets.

Note: NetScaler appliances emit a high-pitched alert if one power supply fails or if you connect only one power cable to an appliance in which two power supplies are installed. To silence the alarm, press the small red button on the back panel of the appliance. The disable alarm button is functional only when the appliance has two power supplies.

CompactFlash Card

The NetScaler software is stored on either the solid-state drive or the CompactFlash card. The following MPX platforms store the NetScaler software on the CompactFlash card:

wCitrix NetScaler MPX 5500

wCitrix NetScaler MPX 7500 and MPX 9500

wCitrix NetScaler MPX 9700, MPX 10500, MPX 12500, and MPX 15500

wCitrix NetScaler MPX 15000

30