Tape Operations

Tape repeat play

The tape repeat continuously plays the current track. This function continues automatically until it is canceled.

1.Press the [RPT] button. “RPT” lights in the display and the current track is repeated.

2.To cancel the repeat play, press the [RPT] button again. “RPT” goes off from the display and normal play resumes.

Blank tape skip

The blank tape skip allows you to skip blank sections of tape that are over 12 seconds long.

1.Press and hold the [RPT] button for more than 1 seconds. The blank skip feature will be set and “BLS” will light on the display. When there is an unrecorded section of more than 12 sec- onds, “BLS” will light on the display and the section will be skipped.

2.To cancel the blank skip feature, press and hold the [RPT] button again for more than 1 second. “BLS” on the display will disappear.

Notes:

The APC, intro tape scan, tape repeat and blank skip may not work properly with tapes of the following qualities:

¥Tapes on which the recording level is too low.

¥Tapes on which there is much noise between se- lections.

¥Tapes on which there are long pauses in the middle of selections.

¥Tapes on which there are less than 4 seconds of blank space between selections.

Operations Common to Each Mode

Setting the clock

1.Press and hold the [TITLE] button for 1 sec- ond or longer to switch to the adjustment se- lection display.

2.Press the [] button.

3.Press the [] or [] button to select the hour or the minute.

4.Turning the [VOLUME] knob either clockwise or counterclockwise to set the correct time.

The clock is displayed in 12-hour format.

5.Press the [] button to store the time into memory.

6.Press the [TITLE] button to return to the pre- vious mode.

Note:

¥You cannot set the clock when it is displayed with only the ignition on. If you drain or remove theÕscar battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled.

Setting the sensitivity of the spectrum analyzer

∗The factory default setting is “MID”.

1.Press and hold the [TITLE] button for 1 sec- ond or longer to switch to the adjustment se- lection display.

2.Press the [] or [] button to select “ANA SENS”.

3.Turning the [VOLUME] knob either clockwise or counterclockwise to set the sensitivity of the spectrum analyzer.

You can choose one of “LOW”, “MID” or “HIGH” for the sensitivity of the spectrum ana- lyzer.

4.Press the [TITLE] button to return to the pre- vious mode.

Setting the speed of the spectrum analyzer display

∗The factory default setting is “LOW”.

1.Press and hold the [TITLE] button for 1 sec- ond or longer to switch to the adjustment se- lection display.

2.Press the [] or [] button to select “ANA SPD”.

3.Turning the [VOLUME] knob either clockwise or counterclockwise to set the speed of the spectrum analyzer display.

You can choose one of “LOW”, “MID” or “HIGH” for the speed of the spectrum ana- lyzer display.

16 ADB340MP/ADB341MP