2. PRECAUTIONS

INFORMATION FOR USERS: .

CHANGES OR MODIFICATIONS TO THIS PRODUCT NOT APPROVED BY THE MANUFACTURER WILL VOID THE WARRANTY.

This equipment has been tested and found to

may cause harmful interference to radio

comply with the limits for a Class B digital

communication. However, there is no

device, pursuant to Part 15 of the FCC Rules.

guarantee that interference will not occur in a

These limits are designed to provide

particular installation. If this equipment does

reasonable protection against harmful

cause harmful interference to radio or

interference in a residential installation. This

television reception, which can be determined

equipment generates, uses, and can radiate

by turning the equipment off and on, the user

radio frequency energy and, if not installed

is encouraged to consult the dealer or an

and used in accordance with the instructions,

experienced radio/TV technician for help.

 

 

English
WARNING

•This device has been designed exclusively for use with a vehicular mounted rear-view television system. It should not be used for other purposes.

•Disconnect the vehicle’s negative (–) terminal when installing wiring.•Do not attempt to disassemble or modify this product.

•In the event it is necessary to drill holes in the vehicle for mounting, confirm that the drill bit or camera wiring will not strike or interfere with piping, gas tank, electrical wiring or other functional parts of the vehicle.

•Do not rely solely on the monitor image when reversing the vehicle.

The rear-view monitor is an auxiliary device meant for confirming the presence of obstacles to the rear of the vehicle, and is limited in its range. It should be used only in conjunction with direct visual observations.

•Always reverse at low speeds.

The rear-view monitor produces a wide-angle image, with the result that actual distances may be different than they subjectively appear in the monitor.

•Do not use when the imaging surface or other parts are malfunctioning.

•When installation and wiring are completed, confirm that the vehicle’s horn, brake and warning lights, and other electrical equipment function properly as designed.

CAUTION•Install only as directed in the Installation Manual.•Install accessory parts as directed.

•When drilling holes in the vehicle for installation of wiring, always use insulated grommets in the holes to protect the wiring.

•If holes are drilled in the vehicle to install the camera, or when installing wiring, use silicon sealant to seal any gaps.

•Do not damage or scar the camera wiring.

•After completing the camera wiring, use cable clamps or insulation tape to bundle the wiring together.

•The images produced from the rear-view monitor are inverted right-left in the same way as images seen in the vehicle’s rear- view mirrors. The image may differ depending on the vehicle type.

•Do not use high-pressure car washing devices around the camera.

The camera is a high-precision instrument and should not be subjected to high-pressure water stream impacts.

•Periodically check the tightness of the installation screws and retighten if necessary.

CC-2011E 3