Installing/Wiring the camera

2. Install mounting bracket A

Using the supplied 2 installation screws (hex head M3 x 6), fasten bracket A to bracket B.

•While tightening the screws, adjust the angle of the bracket A to produce the optimum camera angle.

To mount the camera at a level angle, mount bracket A’s engraved leveling line (——) even with the center of the installation screws when tightening.

Angle adjustment direction

Mounting bracket A

Mounting bracket B

 

 

Installation screws (hex head)

3. Attach mounting bracket C to camera

Using the two pan head installation screws

(M3 x 6), attach the camera to mounting bracket C, using the two hex head installation screws (M3 x 6) as shown, attach the camera and bracket C assembly to mounting bracket A.

Mounting bracket A

Installation screws (pan head)

Installation screws (hex head)

Mounting bracket C

Camera

•Adjust the camera angle as desired when tightening the screws for mounting bracket C.

The camera’s position can be adjusted by selecting from among the three sets of holes on the sides of mounting bracket A.

or

Use one of the three holes.

In addition, the mounting bracket A can be inverted (mounted upside down) if needed to provide additional range of camera installation.

Invert mounting bracket A

CAUTION

•When adjusting the camera position, do not allow the camera cable to be excessively stretched or loose.

•Periodically check the tightness of the installation screws and retighten if necessary.

English

CC-2011E 7