SIRIUS Satellite Radio Operations
English
This function is available when a Satellite Radio Receiver is connected through the CeNET cable.
This unit can control the following satellite radio receivers:
•SIRIUS Satellite Radio Receiver : SIRCL3
•SIRIUS Satellite Translator Adapter :
Notes:
•When the function is differ depending to the connected receiver, they are distinguished by the following notations:
“SIRIUS”: for a SIRIUS Satellite Radio Receiver
Selecting a Satellite Radio mode
1.Press the [SRC] button.
The system changes to the specified Satellite Radio mode.
Channel selection
1.Channels are selected with the [x] or [v] button.
∗For details, see the following operation descriptions.
Note:
•The audio output is muted and other button operations are not accepted during channel selection.
Tuning mode
There are two channel selection modes: quick tuning mode and step tuning mode.
●Quick tuning
1.Press and hold the [x] or [v] button (1 sec.).
●Step tuning
1. Press the [x] or [v] button.
Selecting a band
1.Press the [BND] button to select a band. This changes the reception band as follows:
SR1 ➜ SR2 ➜ SR3 ➜ SR1 ...
●Information displayed during reception The following information is displayed when the satellite radio cannot be received normally.
•When the receiver is turned on the first time or after a reset: “UPDATING”
•When a channel is being tuned in (no signal is yet received): “LINKING”
•A channel without a broadcast has been selected: “INVALID CH”
•A channel not covered by your contract: “CALL 888” ↔
Confirming your SIRIUS ID
1.Press the [x] or [v] button to switch to channel 0.
2.Press the [DISP] button until the SIRIUS ID appears in the diaplay.
Displaying channel labels
1.Press the [DISP] button to select the desired channel label.
Channel ➜ Category ➜ Title (Artist) ➜ Radio text ➜ Channel...
Recalling a preset station
A total of 18 satellite radio stations can be stored.
This allows you to store your favorite satellite radio stations in memory for later recall.
1.Press the [BND] button to select the desired band.
2.Press the [w] / [z] button or [DIRECT] button to select the desired preset station.
Preset memory
1.Press the [BND] button to select the desired band.
2.Select the desired channel with quick tuning or step tuning.
3.Press and hold the [DIRECT] button (2 sec.) to store the current channel into preset memory.
30 CX609
