English
9. IN CASE OF DIFFICULTY
| Problem | Cause | Measure | |||
| Power does not turn | Fuse is blown. | Replace with a fuse of the same amperage. If | |||
| on. |
| the fuse blows again, consult your store of | |||
| (No sound is pro- |
| purchase. | |||
| duced.) |
|
|
|
| |
| Incorrect wiring. | Consult your store of purchase. | ||||
|
| |||||
|
|
|
|
|
| |
| No sound output | Power antenna lead is shor- | 1. Turn the unit off. | |||
| when operating the | ted to ground or excessive | 2. Remove all wires attached to the power | |||
| unit with amplifiers or | current is required for re- | antenna lead. Check each wire for a possible | |||
| power antenna at- | short to ground using an ohm meter. | ||||
| tached. | power antenna. | 3. Turn the unit back on. | |||
|
|
| 4. Reconnect each amplifier remote wire to the | |||
General |
|
| power antenna lead one by one. If the | |||
|
| amplifiers turn off before all wires are | ||||
|
| required). | ||||
|
|
| attached, use an external relay to provide | |||
|
|
| ||||
|
|
|
|
|
| |
| Nothing happens | The microprocessor has | Turn off the power, then | |||
| when buttons are | malfunctioned due to noise, | press the [RELEASE] | |||
| pressed. | etc. | button and remove the | |||
|
|
| DCP. | |||
| Display is not accu- |
| Press the reset button for | |||
| rate. |
| about 2 seconds with a | |||
|
|
| thin rod. |
|
| |
|
|
|
| |||
|
|
|
|
|
| |
|
|
| Reset button | |||
|
|
|
|
|
| |
|
| DCP or main unit connec- | Wipe the dirt off with a soft cloth moistened with | |||
|
| tors are dirty. | cleaning alcohol. | |||
| Compact disc cannot | Another compact disc is al- | Eject the compact disc before loading the new | |||
| be loaded. | ready loaded. | one. | |||
|
|
|
|
|
| |
| Sound skips or is noi- | Compact disc is dirty. | Clean the compact disc with a soft cloth. | |||
| sy. |
|
|
|
| |
|
| Compact disc is heavily | Replace with a compact disc with no scratches. | |||
CD |
| scratched or warped. |
|
|
| |
Sound is bad directly | Water droplets may form on | Let dry for about 1 hour with the power on. | ||||
| ||||||
| after power is turned | the internal lens when the |
|
|
| |
| on. | car is parked in a humid |
|
|
| |
|
| place. |
|
|
| |
|
|
|
|
|
|
10. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
| Error Display | Cause | Measure | |
|
|
|
| |
| ERROR 2 | A CD is caught inside the CD deck and is | This is a failure of CD deck’s mechanism and | |
|
| not ejected. | consult your store of purchase. | |
|
|
|
| |
CD | ERROR 3 | A CD cannot be played due to scratches, | Replace with a | |
| etc. | disc. | ||
|
| |||
|
|
|
| |
| ERROR 6 | A CD is loaded | Eject the disc then reload it properly. | |
|
| deck and does not play. |
| |
|
|
|
| |
| ERROR 2 | A CD inside the CD changer is not loaded. | This is a failure of CD changer’s mechanism | |
changer |
|
| and consult your store of purchase. | |
|
|
| ||
ERROR 3 | A CD inside the CD changer cannot be | Replace with a | ||
| played due to scratches, etc. | disc. | ||
CD |
|
|
| |
ERROR 6 | A CD inside the CD changer cannot be | Eject the disc then reload it properly. | ||
| ||||
|
| played because it is loaded |
| |
|
|
|
| |
| ERROR H | Displayed when the temperature in the MD | Lower the surrounding temperature and wait | |
|
| changer is too high and playback has been | for a while to cool off MD changer. | |
|
| stopped automatically. |
| |
|
|
|
| |
changer | ERROR 2 | An MD inside the MD changer is not loaded. | This is a failure of MD changer’s mechanism | |
|
| and consult your store of purchase. | ||
|
|
| ||
ERROR 3 | An MD inside the MD changer cannot be | Replace with a | ||
| played due to scratches, etc. | disc. | ||
MD |
| |||
|
|
| ||
ERROR 6 | An MD inside the MD changer cannot be | Eject the disc then reload it properly. | ||
| ||||
|
| played because it is loaded |
| |
|
|
|
| |
|
| Displayed when a | Load a | |
|
| loaded in the MD changer. |
| |
|
|
|
| |
| ERROR 2 | A DISC inside the DVD changer cannot be | This is a failure of DVD mechanism and | |
|
| played. | consult your store of purchase. | |
|
|
|
| |
changer | ERROR 3 | A DISC cannot be played due to scratches, | Retry or replace with a | |
| etc. | |||
|
|
| ||
ERROR 6 | A DISC inside the DVD changer cannot be | Eject the disc then reload it properly | ||
| played because it is loaded |
| ||
DVD |
|
| ||
|
|
| ||
ERROR P | Parental level error | Set the correct Parental level. | ||
| ||||
|
|
|
| |
| ERROR R | Region code error | Eject the disc and replace correct region | |
|
|
| code disc. | |
|
|
|
|
If an error display other than the ones described above appears, press the reset button. If the problem persists, turn off the power and consult your store of purchase.
English
24 | DXZ435 | DXZ435 | 25 |