Clarion DXZ938R 8. IN CASE OF DIFFICULTY

English

8. IN CASE OF DIFFICULTY

	Problem	Cause	Measure
	Power does not turn	Fuse is blown.	Replace with a fuse of the same amperage. If
	on.		the fuse blows again, consult your store of pur-
	(No sound is pro-		chase.
	duced.)
		Incorrect wiring.	Consult your store of purchase.
	No sound output	Power antenna lead is shor-	1. Turn the unit off.
	when operating the	ted to ground or excessive	2. Remove all wires attached to the power anten-
	unit with amplifiers or	current is required for	na lead. Check each wire for a possible short
	power antenna	remote-on the amplifiers or	to ground using an ohm meter.
	attached.	power antenna.	3. Turn the unit back on.
			4. Reconnect each amplifier remote wire to the
			power antenna lead one by one. If the amplifi-
			ers turn off before all wires are attached, use
General	Nothing happens	The microprocessor has	an external relay to provide remote-on voltage
			Turn off the power, then
			(excessive current required).
				Reset button
	when buttons are	malfunctioned due to noise,	press the [RELEASE]
	pressed.	etc.	button and remove the
			DCP.
	Display is not accu-		Press the reset button
	rate.		with a thin rod.
		DCP or main unit connec-	Wipe the dirt off with a soft cloth moistened with
		tors are dirty.	cleaning alcohol.
	Compact disc cannot	Another compact disc is	Eject the compact disc before loading the new
	be loaded.	already loaded.	one.
	Sound skips or is noi-	Compact disc is dirty.	Clean the compact disc with a soft cloth.
	sy.
		Compact disc is heavily	Replace with a compact disc with no scratches.
		scratched or warped.
CD
	Sound is bad directly	Water droplets may form on	Let dry for about 1 hour with the power on.
	after power is turned	the internal lens when the
	on.	car is parked in a humid
		place.
DSP	Poor sound quality	The equalizer levels are too	If the equalizer levels are too high, the sound
		high.	may distort. Lower the equalizer levels.

34 DXZ938R