English
7. OPERATIONS
Basic Operations | Note:Be sure to read this chapter referring to the front diagrams of |
chapter “3. CONTROLS” on page 5 (unfold). |
CAUTION
Lower the volume level before powering the source unit off. The source unit stores the last volume setting. If the source unit is powered off with the volume up, when the source unit is powered back on, the sudden loud volume may harm your hearing and/or damage the source unit.
Turning on/off the power
Note:
•Be careful about using this unit for a long time without running the engine. If you drain the boat’s battery too far, you may not be able to start the engine, and this can reduce the service life of the battery.
1.Press the [FNC] button.
2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.
3.Press and hold the [FNC] button for 1 second or longer to turn off the power for the unit.
Note:
•System check
During the initial power up of this unit, it will go through a system check procedure. This procedure verifies any devices connected through CeNET. Any additional CeNET devices plugged into the unit after the initial power up will initiate the system check procedure. The system check starts automatically within the unit.
Selecting a mode
1.Press the [FNC] button to change the operation mode.
2.Each time you press the [FNC] button, the operation mode changes in the following order:
Radio mode ➜ SIRIUS mode ➜ CD mode ➜ CD changer mode ➜ TV mode ➜ AUX mode ➜ Radio mode...
∗External equipment not connected with CeNET is not displayed.
Adjusting the volume
Turning the [ROTARY] knob clockwise increases the volume; turning it counterclockwise decreases the volume.
∗The volume level is from 0 (minimum) to 33 (maximum).
Switching the display
Press the [DISP] button to select the desired display.
Each time you press the [DISP] button, the display switches in the following order:
Main display
Sub display (SIRIUS mode only)
Clock display
Main display
∗Once selected, the preferred display becomes the display default. When a function adjustment such as volume is made, the screen will momentarily switch to that function’s display, then revert back to the preferred display several seconds after the adjustment.
Setting the Z-Enhancer Plus
This unit are provided with 3 types of sound tone effects stored in memory. Select the one you prefer.
∗The factory default setting is “Z+ OFF”.
Each time you press the [Z+] button, the tone effect changes in the following order:
“Z+ OFF” ➜ “B-BOOST” ➜ “IMPACT” ➜
“EXCITE” ➜ “CUSTOM” ➜ “Z+ OFF” ...
12 M455