Operations Common to Each Mode

Setting LOW PASS FILTER

Selecting AUX IN sensitivity

English

This function allows you to set the low-pass filter for sub-woofer output.

∗The factory default setting is “REAR”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “SW LPF”.

3.Turn the [ROTARY] knob to select the setting. Each time you turn the [ROTARY] knob, the setting changes in the following order:

REAR ➜ LPF 50 ➜ LPF 80 ➜ LPF 120

4.Press the [T] button to return to the previous mode.

Make the following settings to select the sensitivity when sounds from external devices connected to this unit are difficult to hear even after adjusting the volume.

∗The factory default setting is “MID”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “AUX SENS”.

3.Turn the [ROTARY] knob to select from “HIGH”, “MID” or “LOW”.

4.Press the [T] button to return to the previous mode.

Adjusting the Subwoofer

When you default select one of mode (LPF50, LPF80, LPF120).

1.Press the [A-M] button and select “S-VOL 0”.

2.Turn the [ROTARY] knob to adjust the subwoofer volume.

The factory default setting is “S-VOL 0”. (Adjustment range: –6 to +6)

3.When the adjustment is complete, press the [A-M] button several times until the function mode is reached.

Adjusting the display contrast

You can adjust the display contrast to match the angle of installation of the unit.

∗The factory default setting is “8”. (Adjustment level: 1 to 8)

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “CONTRAST”.

3.Turn the [ROTARY] knob to adjust the contrast.

4.Press the [T] button to return to the previous mode.

Performing a system check

This function verifies the devices hooked up through CeNET.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “S- CHECK”.

3. Press and hold the [ ] button for 1 second or longer to start the system check.

CeNET connection configuration is automatically checked.

When the system check is complete, the display returns to the previous mode.

AUX function

This system has an external input jack so you can listen to sounds and music from external devices connected to this unit.

18 M455