English

guide start Quick

Installation Notes

WARNING

•Please note the position of pipes, tanks and electrical wirings before installing the unit into the vehicle; failure in avoiding these may cause a fire or malfunction.

CAUTION

•Use only the supplied parts.If unspecified parts are used, they may cause damage.

•Any holes made in the body of the vehicle should be sealed with a silicon adhesive. If exhaust fumes or water penetrates into the vehicle, this may cause an accident.

•Fasten the bolts securely when installing the unit. If the bolts are loose an accident or malfunction could occur.

Connection Notes

WARNING

•Loom all cables according to the instruction manual, so as not to hinder operation.

•Wire the connecting cords/cables away from high temperature areas. If the coatings of the cables melt, it could cause an accident/fire by a short circuit. Take care when wiring in the engine compartment.

•When wiring the connecting cables in a vehicle with an airbag system, never feed the cables through a place where it may affect the operation of the airbag. An airbag not operating correctly in an emergency may cause increased injury.

CAUTION

•Verify wires with a digital multi-meter prior to making any connections.

Many new vehicles use multiplexed and/or low voltage circuits that can be damaged if a test light or logic probe is used.

•Connect cables appropriately. If a wrong connection is made, this may cause a fire or accident.

•When passing cables through the body of the vehicle, use non- conductive grommets. If the coatings of the cables are worn out by rubbing, this may cause an accident, fire or a short circuit.

•After wiring cables, fix them with insulation tape.

•Be sure to switch off the vehicle when connecting or disconnecting cords to/from the unit, otherwise an electric shock, injury or accident may occur.

26NX404