| 5. This unit has a fan motor in the back of the | |
| main unit so as not to raise the temperature | |
English | in the source unit. When the fan motor vent | |
is covered with cords or mounting bracket, | ||
| ||
| it may cause a malfunction. Be sure not to | |
| cover it when wiring cords. |
Quick | 5. Installing the Main Unit | ||
start | |||
|
| ||
This unit is designed for fixed installation in the dashboard. | |||
guide | |||
1. | When installing the main unit in NISSAN vehicles, use the parts attached to the | ||
| unit and follow the instructions in Figure 5. | ||
| When installing the main unit in TOYOTA vehicles, use the parts attached to the | ||
| vehicle and follow the instructions in Figure 6. | ||
| 2. | Wire as shown in Section 7. | |
| 3. | Reassemble and secure the unit in the dashboard and set the face panel and | |
|
| center panel | |
Mounting Screw Holes (Side View of the Main Unit)
For NISSAN vehicle | For TOYOTA vehicle |
Figure 4
Installing the Main Unit in NISSAN Vehicle
Main Unit | Spacer (thickness: 1mm) |
| |
| (Not attached to the main |
| unit) |
Trim ring |
|
(Not attached to Mounting bracket | 6- Flat head screws |
the main unit) | (1 pair for the left and right sides) | (M5x8) |
| ||
|
| |
|
| (Attached to the main unit) |
| Figure 5 |
|
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modification. (Trimming, filing, etc.)
• Removing the Main Unit
When the main unit is to be removed, disassemble it in the reverse of the order in
“INSTALLING THE MAIN UNIT”.
28NX404