English

guide start Quick

Installing The GPS Antenna

WARNING

•Do not install the GPS antenna in a place where it may interfere with the operation of the airbag or hinder the driver’s visual range.

•Do not use the navigation system with the GPS antenna cord cut off. The power cables in the cord may be short-circuited.

Note:

•The supplied GPS antenna is for installing inside the vehicle. Do not install it outside the vehicle.

•Install the GPS antenna more than 50 cm away from the main unit, other audio devices such as CD player, and a radar detector.If it is installed near these devices, GPS reception may be impaired.

•To improve the GPS signal reception, install the GPS antenna horizontally on a flat plane.

•Do not wax or paint the cover of the GPS antenna. This may reduce the performance of the GPS antenna.

•Install the GPS antenna at least 10 cm away from the windshield.

•Wipeoff the dirt of the mounting surface before installing the GPS antenna.

•Mount the GPS antenna.

 

the passenger side dashboard

GPS antenna

where GPS signal interruption is

 

minimized.

 

• Wire the GPS antenna cord.

 

Fasten the cord using the cord

 

holders.

Cord holder

Double-sided tape

• Stick the double-sided tape to the bottom

Cautions on Wiring

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

3. If the fuse should blow, check to see if the wiring is correct.

If a fuse is blown, replace it with a new one of the same amperage rating as the original (15A FUSE).

4.To replace the fuse, remove the old fuse on the back of the unit and insert the new one. (Figure 7)

NOTE:

There are various types of fuse holder. Do not let the battery side touch other metal parts.

CAUTION

After the connection, fix the cord by a clamp or insulation

tape for protection.

Fuse (15A FUSE)

Fuse holder

Figure 7

Bottom face of the GPS antenna

face of the GPS antenna.

30NX404