
English
Headphone components
Power switch | POWER | Power light | |
|
| VOLUME | Volume dial |
Headphones
Installing batteries in the headphones
If this is the fi rst time you’re using the system, install batteries in the headphones.
Change the batteries when you begin to hear distorted audio that cuts in and out.
1.Rotate the left earpiece so the battery cover is accessible.
2.Slide the battery cover down.
3.If replacing the batteries, remove the discharged batteries.
4.Insert the new AAA batteries according to the polarity marked inside the battery compartment.
5.Slide the battery cover back into place.
Setting the volume
Battery cover
Batteries installed
The volume control is on the headphones. Turn the volume dial up or down.
Note:
Some noise may be audible depending on the type of encoder software used while recording. This noise is not caused by the OHM875VD / OHM1075VD / OHM1575VD.
16 | OHM875VD / OHM1075VD / OHM1575VD |
OHMOwnersManual.indd 16
1/5/2007 12:27:00 PM