Clarion XD516 owner manual Troubleshooting, English, Problem, Cause, Measure

English

9. TROUBLESHOOTING

	Problem	Cause	Measure
	Power does not	Fuse is blown.	Replace with a fuse of the same amperage. If the
	turn on.		fuse blows again, consult your store of purchase.
	(No sound is
			Consult your store of purchase.
	produced.)	Incorrect wiring.
	No sound output	Power antenna lead is	1. Turn the unit off.
	when operating	shorted to ground or	2. Remove all wires attached to the power antenna
	the unit with	excessive current is required	lead. Check each wire for a possible short to
	amplifiers or	for remote-on the amplifiers	ground using an ohm meter.
	power antenna	or power antenna.	3. Turn the unit back on.
	attached.		4. Reconnect each amplifier remote wire to the
			power antenna lead one by one. If the amplifiers
			turn off before all wires are attached, use an
General			external relay to provide remote-on voltage
			(excessive current required).
	Nothing happens	The microprocessor has	Turn off the power, then press the Open button 1
	when buttons are	malfunctioned due to noise,	and remove the DCP.
	pressed.	etc.	Press the reset button for about 2 seconds with a
	Display is not		thin rod.
	accurate.
				Reset button
		DCP or main unit connectors	Wipe the dirt off with a soft cloth moistened with
		are dirty.	cleaning alcohol.
	Compact disc	Another compact disc is	Eject the compact disc before loading the new one.
	cannot be	already loaded.
	loaded.
	Sound skips or is	Compact disc is dirty.	Clean the compact disc with a soft cloth.
CD	noisy.
		Compact disc is heavily	Replace with a compact disc with no scratches.
		scratched or warped.
	Sound is bad	Water droplets may form on	Let dry for about 1 hour with the power on.
	directly after	the internal lens when the
	power is turned	car is parked in a humid
	on.	place.

16 XD516