Area 1 See figure 8
Superficie 1. Vea la Figura 8
Zone 1 Voir figure 8
Vacuum only, Para eliminar la after cleaning mayor cantidad each area for de agua posible
maximum sólo realice la water removal aspiración
después de limpiar cada superficie
Figure8A
Figure8B
Aspiration seulement, après nettoyage de chaque zone pour une élimination maximum de l'eau
To clean an area of carpet, follow this procedure:
1.Start the pump for the solution and the motor for the vacuum on the extractor.
2.Begin at the
3.Hold the floor tool at the angle that gives the best vacuum seal between the tool and the carpet.
4.Apply pressure to the lever for solution release. Pull the tool toward you at a slow, steady speed. To remove as much solution as possible, release the lever before you stop moving backward. Push tool away over the same area while moving tool to next position. (Repeat process)
5.To clean the edge of a room, move the tool along the baseboard until the edge of all the carpet is cleaned.
6.To clean a small area of carpet, clean the carpet in sections three feet square. As you make more passes, repeat one inch of the area already cleaned.
7.To remove more liquid from the carpet, make passes over the area already cleaned, but do not apply pressure to the lever for the solution.
How To Clean A Larger Area Of Carpet See Fig. 8B To clean a larger area of carpet, follow this procedure:
1.Begin at the
2.Make a pass halfway along the edge of the carpet. Pull the tool backward at a steady speed.
3.Move to the edge of the carpet. Make another pass next to your first pass.
4.As you make more passes, repeat one inch of the area already cleaned. If you use a power brush tool, repeat one inch of the area already cleaned by the brush. Makeeachpassfourinchesdifferentinlength to prevent making a line in the center of the carpet.
5.Make more passes until half of the carpet is cleaned. To remove more liquid from the carpet, make passes over the area already cleaned, but do not apply pressure to the lever for the solution.
6.Move to the
7.Make a pass halfway along the edge of the carpet.
8.As you make passes, repeat one inch of the area already cleaned.
9.Make more passes until all of the room is cleaned.
CAUTION: Clarke will not be held liable for damage to the carpet, or poor results because of the operator's lack of ability.
Page 22 | Clarke® BEXT® |