5.If the extractor removes an excess amount of foam from the carpet, add a de-foamer such as Clarkare® De-foamer Concentrate to the recovery tank. The amount needed will vary according to the amount of detergent already in the carpet.

CAUTION:

To prevent damage, use a water-based de-

CAUTION:

foamer ratherthananoil-basedde-foamer.

Donot leavetheextractororothercleaning

 

machines or tools on the carpet when not

 

in use. Cleaning solution in the machines

 

and tools can leak onto the carpet and

 

cause light spots or stains.

NOTE: To order Clarkare® Extractor Concentrate, order part no. 398421. To order Clarkare® Defoamer, order part no. 398420.

For instructions for preparation and operation of your floor tool, read the instruction sheet given with your floor tool.

BEXT®-100 Control Panel

12

VACPUMP

Figure 4

VACUUM SWITCH (1 ): The vac switches illuminate when turned on.

PUMP SWITCH (2): This switch will illuminate when the pump is on.

BEXT®-100H Control Panel

1

LOCATOR

2 3 4

VAC PUMP HEAT

Figure 5

CIRCUIT LOCATOR (1):When this light is on, it indicates that cord #2 is on a separate line from cord #1. Cord #2 supplies voltage to the heater allowing it to heat to the proper temperature range.

VACUUM SWITCH (2): The vacuum switch will illuminate when the vacuum motor is turned on.

PUMP SWITCH (3): This switch will illuminate when the pump is on.

HEAT SWITCH (4): The heat switch will illuminate when it is activated and will turn the heater on.

Page 16

Clarke® BEXT® -100, 100H 150H, 300HV Operator's Manual