OPERATORSAFETYINSTRUCTIONS(CONT.)

WARNING: Improper discharge of waste water may damage the environment and be illegal. The United States Environmental Protection Agency has established certain regulations regarding discharge of waste water. Also, city and state regulation regarding this discharge may be in effect in your area. Understand and follow the regulations in your area. Be aware of the environmental hazards of chemicals that you dispose.

CAUTION: To prevent damage to the power cord, do not move this machine over the power cord, instead, lift the power cord over the machine. If the cord supplied is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualifed person in order to avoid the hazard.

CAUTION: To prevent damage to the power cord and hoses, do not use the power cord or hoses to pull the machine.

CAUTION: To prevent damage to the machine avoid extreme temperatures. CAUTION: To prevent damage to the machine do not let pump run dry.

INSPECTION: Carfefully unpack and inspect your new Extractor for shipping damage. Each unit is tested and inspected before shipment. Any damage incurred is the responsibility of the carrier, who should be notified immediately.

CLEANING SOLUTIONS: We recommend liquid cleaning chemicals. A pH of 7-9 is strongly recommended to avoid premature pump wear, which would voide the warranty.

INTRODUCTION andMACHINE SPECIFICATIONS

•The Model BEXT®-100, 100H, 150H or 300HV is an extractor for cleaning carpet. When used with a floor tool, the machine applies cleaning solution to the carpet and removes the dirty solution and soil from the carpet.

•The extractor has controls to start the pump for the solution and the motor for the vacuum. The floor tools have controls to release the solution.

•The extractor has a bypass pump. The pump runs when switched on, bypassing solution internally to keep pressure even.The extractor starts when the solution lever on the floor tool is activated.

SPECIFICATIONS

Bext 100

 

Bext 100H

 

Bext 150H

 

Bext 300H

 

 

 

Bext 100H Detailer

 

Bext 150H Detailer

 

 

Part Number

04156A

 

04157A / 04158A

 

04147A / 04152A

 

04148A

Solution Tank

9 gallon rotationally molded

 

13 gallon rotationally molded

Solutin Pump

100 psi demand pump

 

150 psi demand pump

 

300 psi demand pump

Vacuum Motor

 

5.7", 3 stage

 

(2) - 5.7" 2-stage

 

7.2" 3-stage

Waterlift

 

140"

 

150"

 

140"

Easy Circuit Locator

N/A

 

Standard

 

Standard

 

Standard

 

 

 

 

 

 

 

 

On-board Heater

N/A

 

Standard

 

Standard

 

Standard

Wand

 

 

Double bend twin nozzle polished stainless steel

 

Power Cable

25 ft. 12-3 hosp.

 

(2) 25 ft. 12-3 hosp. grade plug

 

 

grade plug

 

 

 

 

 

 

Wheels

(2) 8" non-marking & (2) 3" casters

 

(2) 10" non-marking & (2) 2" casters

Hose

 

15 ft. crushproof vacuum and high pressure solution line

 

Low Moisture System

 

 

Standard

 

Float Shut-Off

 

 

Standard

 

Weight

69 lbs.

 

75 lbs.

 

90 lbs.

 

119 lbs.

Warranty

Product Lifetime (10 years) on tank and mainframe; 1 year Parts and labor

 

 

 

 

 

 

 

 

NOTE: When using the extractor to clean carpets, follow this procedure:

1.Do not walk on freshly cleaned carpets for at least four hours or until the carpet is dry to touch.

2.Do not remove aluminum or plastic pieces that have been placed under the legs of furniture until the carpet is dry.

3.Do not allow children or pets to crawl or walk around on the damp carpet.

4.Vacuum right after the carpet is dry and then vacuum the carpet once a week as needed.

Page 6

Clarke® BEXT® -100, 100H 150H, 300HV Operator's Manual